Electric meter box developed by ZFY TECH(Zhejiang Zhongfeiya Technology Co., ltd),made of new environmentally friendly engineering plastic polycarbonate (PC), it has high insulation performance, good transparency, UV resistance, aging resistance, acid rain resistance, salt spray resistance, high temperature resistance, low temperature resistance, impact resistance and other properties, and good Ventilation, rainproof, heat dissipation and other functions, the normal service life is more than 30 years.
Electric meter box cover adopt the integrated design concept, which integrates various electric meters and the entire metering circuit in an integrated closed box, which not only takes up a small space and is easy to install and manage, but also prevents the thief from touching the metering device and prevents electricity theft.
This series of meter boxes are beautiful in appearance, well-proportioned, and smooth in lines. They can be easily and firmly installed on the concrete wall through the reserved bolt holes on the back. The components in the box have a compact structure, a reasonable layout, and a smooth and clear line direction. The box cover is interlocked with the box body through a hook, a special screw and a padlock, and only the electrician can open it with a special screw wrench and key. The lid of the box is crystal clear, and the electrician can directly see all kinds of abnormal phenomena in the box without opening it, so as to eliminate potential safety hazards in electricity use in advance, so as to achieve the management goal of "safe electricity use, prevention first".
This series of meter boxes has been launched since its introduction. With its unique design, novel craftsmanship and advanced performance, it is favored by more and more power supply companies.
1. Product scope and conditions of use
Meter box includes two parts: single-phase meter box and three-phase meter box. It is suitable for AC 50Hz or 60Hz, rated working voltage to 220V, 380V, 690V, and rated working current of 10A~225A for single-phase power supply system. The measurement and control management of electric energy and power electric energy.
Conditions of Use:
● The ambient temperature is -25°C~+50°C, and the average temperature within 24 hours does not exceed +35°C.
● The air is clean, the relative humidity does not exceed 80% at 40°C, and higher relative humidity is allowed when the temperature is lower.
2. Product specifications and models (see product center for details)
3. The main technical parameters of the product
●Main bus rated current In: 225A~10A
●Main busbar rated short-time withstand current Iow: 30KA
●Insulation resistance: not less than 20MΩ
●Rated insulation voltage Ui: 800V
● Frequency: 50Hz or 60Hz
●Safety protection grade IP: 43
The main configuration of the product (see product center for details)
Product installation and use
● Please carefully check the integrity of the components of the meter box during installation.
● The meter box should be installed vertically. The inclination angle must not exceed 54°.
● The installation location should be selected where there is no severe vibration, impact, and not enough to corrode electrical components.
●Because the materials used in the meter box are not resistant to strong alkalis, oxidizing acids, amines, and ketones. It is soluble in chlorinated hydrocarbons and aromatic solvents. So avoid contact with these chemicals or use them together. Avoid sharp objects and hard objects from scratching the surface of the meter box during use.
● When installing the meter box, choose a cool and dry place as much as possible to avoid direct sunlight for a long time to extend the service life of the meter.
●The fixing positions for the meter box to be fixed to the wall or the cross arm are located inside the box, so the box must be opened before installation, first remove the two upper cover fixing screws located in the lower middle of the meter box, and then follow the instructions here Open the cabinet.
●According to the position of the mounting hole, drill the mounting hole in the corresponding wall position, place the expansion tube, then fix the base to the wall, and install the upper cover.




