Improvement Measures for Common Failures of Electric Distribution Boxes
When the distribution box is running, it is inevitable that there will be failures. For some common failures, some improvements can be made to the distribution box. Below, the editor will take you to understand:
1. If you add a column-mounted power distribution stand, you can choose 2mm thick stainless steel plates when making the enclosure of the distribution box, and enlarge the size of the distribution box appropriately to increase the distance between the outlets of each branch, and the outlet and the box. The electrical safety distance of the body shell is conducive to the operation and maintenance of agricultural electricians and the replacement of melting parts, and it can also dissipate heat.
2. Selection of residual current operated protector. Products that meet the GB6829 standard and are certified by the China Electrical Products Certification Committee must be selected. A time-delay protector similar to the LJM (J) series of energy-saving and low sensitivity can be selected. 3. The protection circuit is used to prevent the occurrence of external circuit failures of the power supply of the distribution box. Choose a small-sized intelligent lack-phase protector, such as DA88CM-II motor lack-phase protection module, installed in the distribution box to prevent the motor from burning out due to low-voltage lack-phase operation.
4. Selection of fuse. The rated current of the total overcurrent protection fuse on the low-voltage side of the distribution transformer should be greater than the rated current of the low-voltage side of the distribution transformer, generally 1.5 times the rated current, and the rated current of the melt should be in accordance with the allowable overload multiple and fuse of the transformer The characteristics of the device are determined.
5. Improve the wiring method of the low-voltage capacitor bank of the original distribution box, and change its installation position from the top of the AC contactor to the connection between the low-voltage incoming line of the distribution box and the meter. Prevent the inaccurate measurement of the metering device due to the lack of phase failure of the capacitor circuit or the damage of the capacitor during operation.




